Bodyguard T240P Owner's Manual download pdf (Page 36)

T240 – T240P – T240C TREADMILLS OWNER’S MANUAL

6.3 Lubricant Application

1. Clean the deck surface and the inside part of the running belt with a dry piece of

fabric. Clean the belt first with a cloth that covers the width of the belt and start the belt

so it makes two (2) complete turns at low speed. Then, release the tension on the rear

roller by loosening the bolts so as to gain easy access to the platform.

2. Open the tube of lubricant supplied by your dealer. Place the tube under and in the

middle of the belt at about 15 inches from the hood cover. Step on the treadmill and

step down with your feet where the lubricant tube is located under the belt to make

sure that most of the lubricant is spread evenly on the deck surface. DO NOT START

THE TREADMILL YET!

3. Remove the LUBE TUBE from under the belt and put the tension back again on the

rear roller. Stand where you applied the lubricant and press JustGo

twice to start

the belt turning at 0.5 mph (or 0.8 km/h). Let the belt bring you to the back of the

treadmill and then return to where you were standing. Do this three (3) times to spread

the lubricant over the total surface of the deck. Start the treadmill and get the speed

up to 2 mph or 3.2 km/h to make sure the belt alignment is correct. If problems occur,

please refer to Table 3 of this document.

6.4 Quick Troubleshooting Checklist

If you experience a problem during the normal operation of your T240–T240P–T240C treadmill, refer to the following

Troubleshooting Guide. If you are unfamiliar with or uncertain about basic Diagnostic maintenance procedures, contact your

authorized BODYGUARD Fitness distributor.

Troubleshooting Checklist - Table 3

PROBLEMS LIKELY CAUSES / SOLUTIONS

• Computer will not light up when

computer is turned ON

• Unit is not plugged in / Plug unit in

• Power cord / Check that power cord is functional; replace it if necessary

• Circuit breaker / Reset the breaker

• Damaged motor drive board / Contact your Bodyguard

distributor

• The wires are not connected / Remove the hood and connect the wires properly

• Belt does not turn • Magnetic key is not in place / Insert the magnetic key

• Incline does not respond properly

• It is not calibrated / Perform Incline Calibration

• The wires are not connected to the motor circuit board / Connect the incline

motor to the motor board

• Motor drive does not respond

properly

• Perform a motor test

• The wires are not connected to the motor circuit board / Motor wiring harness

needs to be connected to the lower board

• Motor turns backwards

• The wires are reversed on the circuit drive / Contact your Bodyguard

distributor

1 2 ... 31 32 33 34 35 36 37 38

Comments to this Manuals

No comments

Bodyguard T240P Owner's Manual Page 36

Comments to this Manuals

Related products and manuals for Treadmills Bodyguard T240P