Bodyguard T700 Owner's Manual download pdf (Page 33)

Error Codes

Table 4

PROBLEM

• Error 1

• Error 2

• Error 11

• Error 12

• Error 21

• Error 22

• Error 23

• Error 31

• Elevation

Motor

Error

• Motor drive

error

CAUSE / SOLUTION

• Acceleration is too quick in the acceleration or reached speed phase.

• Possible causes: Motor drive defective or user pushing on the running belt for too long.

• Running belt not following the speed required in the reached speed phase.

• Possible causes: Deck too sticky. Walk on deck for 15 minutes at 4 mph.

• Motor drive board can be defective.

• Check speed sensor or optical disk.

• Acceleration is too fast during acceleration phase.

• Possible cause: Defective drive board.

• Acceleration is too slow during acceleration phase.

• Possible causes: Deck too sticky.

• Walk on deck for 15 minutes at 4 mph.

• Speed sensor problem.

• In a deceleration phase, the speed slows down too fast.

• Possible cause: Drive board defective.

• In a deceleration mode, the speed slows down too slowly.

• Possible cause: Drive board defective, speed sensor problem.

• There is an abnormal acceleration during the deceleration phase.

• Motor drive board is defective.

• Acceleration is too quick under 2 mph.

• Possible causes: Motor drive defective or user pushing on the running belt for too long.

• Elevation motor values from potentiometer are out of range.

• Possible causes: Elevation motor is defective or uncalibrated.

• Perform an elevation calibration in the diagnostics menu.

• Motor drive board can be defective.

• Elevation Motor not functionnal.

• Elevation Motor not connected.

• A problem occurred on the motor control board. Contact your Bodyguard

Dealer to give this

information. This will help ﬁnding the cause.

1 2 ... 28 29 30 31 32 33 34 35 36

Comments to this Manuals

No comments

Bodyguard T700 Owner's Manual Page 33

Comments to this Manuals

Related products and manuals for Treadmills Bodyguard T700